Therefore, I have undertaken the job of trying to rewrite it.Im hoping that others with more experience might help to edit it for accuracy.Also, there may be more information than I have been able to squeeze from the manual.
The Y axis on my DRO has the decimal point located in front of the inch digit instead of after it. The X axis is OK. Other than that, I am rapidly growing quite fond of this addition to my lathe. If any are interested, please PM me and well see if we can find another way to get together on this. Did you attempt to contact the manufacturer I contacted them for info a while back and they were pretty quick to respond. I have a Clausing Master 13x36 coming and will be setting up a DRO on it. The Sino is one I was looking at, although I may attempt to use the glass scales I have from an Accurite III. I looked at the SINO web site, but I cannot read Chinese, so it was of no help. There is an international phone number on the install manual, but Id rather just put up with the minor inconvenience than try to make that call BTW, that manual is easy to interpret - it says Just figure it out yourself. I will take my time, perhaps a few photos and post them as I go along, a re-write of this manual would be an asset to anyone who purchases any of these units.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |